OSHA 10-Hour General Industry Safety Training: 29 CFR 1910

Don’t be caught unprepared!

This 10-hour General Industry Outreach training program was developed by the Occupational Safety and Health Association (OSHA) to provide important safety information on fundamental OSHA standards for General Industry. SFMA is partnering with the American Training Institute (ATI) to deliver this important program to SFMA members and associates. The ATI specializes in compliance training and consulting to assist manufacturers in complying with the OSHA Title 29 CFR 1910 requirements. The classes are designed to be presented with an emphasis on hazard identification, avoidance, control and prevention, NOT OSHA standards!

Staying current with OSHA General Industry regulatory training requirements can often be an overwhelming task. Did you know that lack of knowledge is one of the most common reasons companies are cited for violations? The objective of this program is to ensure that your company, no matter how large or small, is prepared to avoid costly accidents and the subsequent OSHA inspection. Don’t be caught unprepared!

This covers the following areas:

 Introduction to OSHA – OSH Act, General Duty Clause 5(a)(1), Inspections, General Health and Safety Provisions
 Walking and Working Surfaces
 Hazcom "Right to Know"
 Electrical Safety
 Personal Protective Equipment
 Confined Spaces
 Machine Guarding
 Machine Guarding
 Emergency Action/Fire Prevention
 Fall Protection

You will receive:

 Classroom Materials
 OSHA Certificate of Completion Card
 American Training Institute Certificate

Course Instructor: Oakley Keller, REP, OHST, CHMT
Authorized OSHA Instructor

WHEN: Wednesday, July 23, 2008

TIME: 8:00 p.m. - 5:00 p.m.

WHERE:  B/E Aerospace

COST: $ 245.00 - Members
             $ 345.00 - Non-members